Applicable to the rotor thickness: 10.0 ~ 90.0mm; b) applies to the rotor diameter: φ25.0-100.0 mm; c) rotor "V" shaped support frame suitable support shaft length: not less than 250mm, and both sides of the support frame can be mobilized; d) after turning the rotor surface roughness: less than 1.6; taper <= 0.01mm, outer diameter runout <0.03mm. e) Support the rear axle turning circle runout: less than 0.02mm, the rotor concentricity less than 0.03mm; f) the amount of not less than the design maximum turning unilateral 0.4mm (6mm shaft when the branch), and to ensure the surface finish. g) the use of Taiwan's precision finishing of cast iron rails, precision knives, hydraulic systems from Taiwan, Taiwan, Eastern brake motors, controlled by the PLC. With automatic cleaning device. This machine is fully automatic lathe, automatic loading and unloading using means. 
 There are manual and automatic finishing machine